BIGTREETECH Flexible Steel Platform,New Upgrade Zone-Heating Hot Bed with PEI Surface and Magnetic Bottom Sheet Adhesive 235×235mm For Ender-3 Pro, Ender-3,Ender-3 V2, BIQU B1, BIQU Hurakan 3D Printer

Introduction to the new zone heating hot bed:

Advantage 1: This hot bed uses zone heating without the support of the main board, and the hot bed can also achieve zone heating in the middle range of 125 * 125MM. It is applicable to more than 90% of ENDER-3 series models on the market.

Advantage 2: The heating time is 20% faster than that of ordinary hot bed.

Advantage 3: When the printing model range is within the middle range of 125MM * 125MM, there is a partition switch on the hot bed to turn it off, which can save 60% of the electricity. The measured 24 hours can save 0.5 kilowatt-hour electricity, and achieve energy saving.

Advantage 4: The new zonal hot bed adopts a new spray technology. The black spray is more viscous than the gold PEI. When the printing PLA temperature is at 60 degrees, the viscosity is 20% better than the gold PEI.

Advantage 5: The new PEI spray has its own zone indication range, which is easier to drop than the printing on the market, and has been perfectly solved on our new black PEI.

Advantage 6: The new zoned heat bed uses an intermediate heat insulation slot to make the temperature in the range of 125 * 125MM in the middle transmit to the edge more slowly, thus solving the unnecessary heat loss.

1. The printing size of the hot bed is 235mmX235mm; The fixed leveling hole position is 170mmX170mm; The partition area is 125mmX125mm.
2. The hot bed is designed with 24V voltage, with maximum power of 240W and minimum power of 100W (zoning function).
3. When using the hot bed, the printer needs at least 24V&300W power supply of the whole machine, which can perfectly replace and support all printers with a printing area of 235mmX235mm and a leveling hole of 170mmX170mm.
4. Compatibility: Compatible with Ender-3/End-3 Pro/End-3 V2, BIQU-B1, BIQU Hurakan, Elego Neptune 3 Pro, Anyubic Kobra, SUNLU T3/Two Tree BLU-3, Longer LK4 Pro, etc 3D Printer。
5. Warm reminder: the positive and negative poles cannot be connected reversely. Reverse connection will cause the power indicator to be off, but the function is normal. If you have any questions when using, you can contact us at any time, and we will solve the problem for you.