XUCHIL Trianglelab USB Adxl345 Accelerometer Compatible with Kilp-per Input Shaper Auto-Calibration USB Interface 3D Printer

USB ADXL345
adxl345 for Kilp-per Input Shaper auto-calibration usb interface User friendly
Technical Details:
USB-ADXL345 Board for Klipper: Installation Manual:
1. Connect the USB-ADXL345 board to the host where the Klipper firmware is installed via the included USB type-c cable. As the Klipper firmware has been flashed to the kit before shipment, the LED of PC13 will light up.
2. Enter the command line of Klipper host device and execute the following command to find the MCU name of the newly connected USB-ADXL345 board.
ls /dev/serial/by-id/*
There will be at least two MCU names. stm32f103 should be the name of the newly connected board It should report something similar to the following;
/dev/serial/by-id/usb-Klipper_lpc1768_0C200115E11C3BAF4A98495CC22000F5-if00
/dev/serial/by-id/usb-Klipper_stm32f103xe_37FFDB054B52393576550543-if00.
3. Save the name of the reported USB-ADXL345 board MCU.
4. Create a new file named usb-adxl345.cfg in the same directory as printer.cfg
5. Add the following to the usb-adxl345.cfg file and change the MCU name below to the name you previously found.
[mcu USB-ADXL345]
serial: /dev/serial/by-id/usb-Klipper_stm32f103xe_xxxxxxxxxxxxxxxx-if00
[adxl345]
cs_pin: USB-ADXL345:PA4
spi_bus: spi1
[resonance_tester]
accel_chip: adxl345
probe_points: 100, 100, 20 # an example
NOTE: It is advised to start with 1 probe point, in the middle and slightly above the print bed.
probe_points: 100, 100, 20 # an example
6. Add on e line to the printer.cfg file:
[include usb-adxl345.cfg]
7. Restart the Klipper service after saving the file. You are good to go. HERE
What’s in the box:
USB-ADXL345 board x1
USB type-C cable 2M x1
USB port extension cable x1
USB to TTL board x1
Blu-Tack Reusable Adhesive
du-pont jumper 4p
Note: please carefully check before ordering to ensure that this is what you need. thank you!

1.Easy to use usb interface
2.Compatible with all klipper host devices
3.Adheres to any surface