BIGTREETECH TMC5160T V1.0 SPI Stepper Motor Driver Ultra-Silent Drivers Support SPI with Heatsink for Manta M8P/Octopus/Octopus Pro/SKR 3/SKR 3 EZ/SKR Pro 3D Printer Control Board (4 PCS)

TMC5160T V1.0 is a high-power stepper motor drive control chip with external expansion rate MOS tube, the maximum current can reach 20A, and the heat is low when working.

Supporting TRINAMICS’ unique stealthChop2 mode eliminates motor noise by reducing resonance, achieving silent effects, and stallGuard2TM stall detection, which safely detects the motor’s stopping action and replaces a mechanical stop switch. Stepper motor torque control or sensorless homing can be achieved.

DcStepTM allows the motor to operate near its load limit and speed limit, achieving a dynamic range of 10x or greater without any out of step.

SpreadCycleTM high-precision chopper algorithm for high dynamic motor motion and produces absolutely clean current waves. Low noise, low resonance and low vibration chopper.

CoolStepTM current control feature optimizes drive performance, balances speed and motor torque, optimizes energy efficiency, delivers smooth and noise-free, and reduces energy consumption by 75 percent.

The TMC5160T extends the TMC2100, TMC2130 and TMC5130 series to higher voltages and higher motor currents.

Driver chip: TMC5160-TA;

Product size: 15.3mm*20.4mm;

Power supply voltage (VM): 8V—35V;

Maximum current: 3A (sampling resistance determines the maximum current);

Maximum breakdown: 256;

Working mode: SPI mode

Special Note: Currently only Marlin2.0 and above firmware supports the SPI mode of the TMC5160T.

🌀TMC5160T V1.0 is a stepper motor driver with ultra-quiet mode and small heat.
🌀TMC5160T V1.0 is not easy to lose step and can prevent the motor from shaking.
🌀TMC5160T V1.0 is a high-power stepper motor drive control chip with external expansion rate MOS tube, the maximum current can reach 20A.
🌀TMC5160T V1.0 can drive 57 stepper motors, Stepper motor torque control or sensorless homing can be achieved
🌀Special Note: Currently only Marlin2.0 and above firmware supports the SPI mode of the TMC5160T.